Products

1 pcs. IC YM2424 OPZ2 V50Semiconductors and electronic assemblies are sensitive to electrostatic charge. Please observe the regulations on ESD handling.The exchange and return of semiconductors and electronic assemblies is excluded after opening the packaging.

1 pcs. MN3102 BBD Driver DIP8Panasonic MN3102 CMOS Clock Generator/Driver for Low Voltage Operation BBD DIP8This IC is out of production. Mechanical Description:The IC is housed in a DIP 8 package and is designed for trughhole mounting on a circuit board. THis chip is pin compatible to Panasonic MN3009.ICs are sensitive to static charge! Handle with care.Semiconductors are excluded from exchange.  

1 pcs. IC PWM GENERATOR YM3421-F HQ SERIESSemiconductors and electronic assemblies are sensitive to electrostatic charge. Please observe the regulations on ESD handling.The exchange and return of semiconductors and electronic assemblies is excluded after opening the packaging.

1 pcs. POWER TRANSFORMER CEE E 01V96Semiconductors and electronic assemblies are sensitive to electrostatic charge. Please observe the regulations on ESD handling.The exchange and return of semiconductors and electronic assemblies is excluded after opening the packaging.

1 pcs. SPEAKER 45.7 CM 4 OHM DSR118WSemiconductors and electronic assemblies are sensitive to electrostatic charge. Please observe the regulations on ESD handling.The exchange and return of semiconductors and electronic assemblies is excluded after opening the packaging.

1 pcs. Service Kit Kawai RN88 PWB Assy KKB-039(2)This service kit replaces the circuit boards and contact rubbers in the Kawai WR88 keyboard. Only possible as a replacement for keyboards in which contact rubbers with three contacts per tone were used.This set of boards replaces the board KKB-039(2).The set consists of two boards, fully equipped with new contact rubbers.These Board fit in these e-pianos:Kawai CA67Kawai CA78Kawai CA79Kawai CA97Kawai CA98Kawai CA99Kawai CS8Kawai CS11 

Fatar TP/8P Keyboard, Replacement keys semi weighted ivory Fatar TP/8P keyboard is a touch sensitive Pianokeyboard with semi weighted keys.Keys are mounted on a support frame with core of steel sheet. At these core all attachments were made of plastic in an injected machine.contact detection is done via 12 pin contact rubber strip with two graphite points.The semi weighted keys have a length of 19,5 cm and a width of 2.24 cm. The thickness of the keys is 1,2 cm. Key guidance and upper stop point are implemented in this keyboard through an eye at the key bottom. The contactor, which presses the contact rubber strip is  worked out by an increase of 11 mm. The distance from the front side of the key is 12,5 cm. At the end of the key is a semi-circular passage aperture into which a spring is hooked.The keys are in color cream white. 

1 pcs. Kawai Volume Slider Knob for CA/CN Serie Black1/Ivory1Kawai CA95Kawai CN23 Technical Description of Kawai Button:This Volume Slider knob will be put on slide potentiometer on your Kawai Pianos 

1 pcs. Blue LCD Display with LED Backlight replacement including cable Kit forKurzweil PC3A6Kurzweil PC3A7Kurzweil PC3A8We offer an absolutely equivalent display using modern LED technology for backlight.Note on the PC3X series from Kurzweil:The replacement display offered here is the appropriate replacement for Kurzweil displays that already use LED backlighting. This can be identified by a short 2-pin connector to the right of the display. Color: White Character  /  Blue BackgroundDelivery scope:Display ready wiredMounting partsInstruction for replacement  Notes on installation The LCD Display in Kurzweil PC3XThe original Kurzweil display has different dimensions to today's commercially available displays. We have therefore developed an adapter board to adapt this. We supply the display pre-wired and pre-assembled.This work is to be done only by technically, best electrotechnically savvy people.The contrast and brightness of the display can be adjusted as usual using the controls in the instrument.No soldering required.All you need is a screwdriver and a side cutter. 

1 pcs. Roland Juno 106 Display Bezel blue newThis display bezel can replace the original display bezel on the Roland Juno-106. Due to the age of the Roland Juno-106 synthesiser, it is possible that the original bezel is scratched. It is also possible that the plastic has become brittle and must be replaced for this reason. Note on mounting the display bezel in the Roland Juno 106:It is best to use double-sided adhesive tape to stick the new display bezel in place. This adhesive tape can be purchased in suitable widths of e.g. 2 mm.

1 pcs. Kawai NV5 Pedal Potentiometer with cableThis is a replacement Poterntiomter for Damper Pedal from E-Piano.Electrical properties:The nominal resistance has 10 kOhm.Appearance (technical characterisation):This Potenziometer is a very spezial part. This one will only fit for Pedal.Useful hint:The potentiometer is soldered on the circuit board. You should have mechanical skills and experience in soldering to replace it.  

1 pcs.MN3207 1024 Stage BBD DIP8The MN3207 is a 1024 stage low voltage operational (5Volt) BBD that provides a signal delay of up to 51,2 ms at clock frequnecy 10 KHz and is suitable for use as reverberation effect of audio equipment.Mechanical Description:The IC is housed in a DIP 8 package and is designed for trughhole mounting on a circuit board.Practical information to MN3207:The IC is permanently soldered onto a circuit board. Replacement requires manual dexterity and soldering experience.ICs are sensitive to static charge!

Key's 16N unweighted suitable for Yamaha This keyboard is used in these modells:Yamaha PSR-e403Color: whiteThis key is newmechanical construction:Keys for this Keyboard are not available as single keys. One Octave will be a set of three single spare parts. One part for the black Keys. One part for D/A/F, and one part for C/E/F/B.

1 pcs. Yamaha Disklavier DRIVE B Circuit Board XL114D0  -- Discontinued -- Semiconductors and electronic assemblies are sensitive to electrostatic charge. Please observe the regulations on ESD handling.The exchange and return of semiconductors and electronic assemblies is excluded after opening the packaging.

Replacement Keys for Technics SK25 KeyboardSK25 keyboard is used in Technics PR-603Technics PR-703 Color: pur whiteThe SK25 keyboard is a touch-sensitive keyboard with 4-zone hammer mechanics.The unweighted keys have a length of 21.4 cm with a width of 2.24 cm. The depth of the key is 5.7 cm measured from the top of the key to the lower end of the key stroke. The top dead center stop is realized by a hook at the lower end of the key. The contactor, which presses on the contact strip, is not formed on the keyboard but on the hammer. At the back end, the key is held in the keyboard frame by means of a slot. The black keys have a length of 16.4 cm with a width of 1.2 cm. 4-Zone Hammer Mechanics:A 4-zone hammer mechanism is now state of the art for high-quality e-piano keyboards. By means of the four different zones the keyboard manufacturers try to get closer to the feeling of a mechanical wing. The keystroke on a mechanical piano varies depending on the area, whether bass or high. This is simulated with this keyboard by the fact that there are four different hammers with different weight. mechanical construction:The base of the keyboard is made of steel sheet and is very stable and rigid. All other components are attached to this frame by screwing or clamping. Particular mention should be made of the structure of the hammers. The hammers used here are made of a continuous metal part, which should guarantee a long life for these hammers. Only the attached plastic parts appear quite graceful.

 1 pcs. PP Capacitor 100 nF X2 Safety

1 pcs. PCB Set for Korg ARP Odysseincluding: KLM-3304,-3005,-3006,-3007,-3008,-3009

1 pcs. Yamaha RCA stereo jack YKC21-3120 These phone jack is firmly soldered to a circuit board. For replacing craftsmanship and experience in soldering is required. 

Yamaha 14Y replacement keys  mechanical construction:The keys for this keyboard are not available individually. Only one octave with 12 keys or the end octave with 13 keys is available. 

Fatar replacement keys for the TP40/W keyboard (used)The Fatar TP/40 Wood (TP40/W) is a special version of the TP/40 family with a wooden core in the white keys and an “ivory feel” surface finish, which is used in high-quality musical instruments. It is used, for example, in Studiologic devices and is also installed in the expensive master keyboard from the Austrian keyboard manufacturer Lachnit. In addition, the TP/40 Wood is used in instruments that are mainly digital pianos, such as the Nord Piano. The TP/40 Wood belongs to the TP/40 family and is therefore interchangeable with other keyboards in this family by means of screws and plugs, provided that the diode polarity “DF” (common anode) is observed.

1 pcs. Power cabel 2m with 2P plug for Yamaha  InstrumentsVDE testedCable: H05VV-F2G0,75mm²Socket: C10Mains plug CEE 7/7 earth contactLength: 2 m  

1 pcs. Yamaha MKH contact PCB FSX76 D2I+ KeyboardThis PCB is for high part in Keyboard 

1 pcs. Yamaha MKH contact PCB FSX76 D2I+ KeyboardThis PCB is for lower Keyboard part. 

1 pcs. Yamaha MKC contact PCB FSX76 D2I+ KeyboardThis PCB is for center Keyboard part.