Spare parts and replacement keys for Roland D-Series Synthesizer

1 pcs. CR2032 Attention: Shipping for Europe only Technical Description: The dimensions of CR2032 are diameter of 20 mm and a thickness of 3mm. Manufacturer: Panasonic or Varta Information for handling old Battery's

tactile switch suitable for models Roland Roland D-550 Roland MKS-50 Roland MKS-70 Roland Spare Part Number: 13129733 The buttons are firmly soldered to a circuit board. For replacing the button craftsmanship and experience in soldering...

Single Button for 17 x 5 mm (No Window) Roland U-20 Do you know this: the button you activate don't react. This processs starts slowly and in the beginning do don't recognice it. Later you start to activate the buttons harder...

Digital-Analog-Converter for audio application for Roland E-Pianos PCM56P von Texas Instruments This part is used from Roland Roland part number:15209122 Resolution: 16bit Interface: seriell Conversion rate: 666kS/s Number of DAC...

1 pcs. PCM54HP - Digital-Analog-Converter for audio application von Burr Brown This part is used in Korg M1 Korg T1 Korg T2 Korg T3 Resolution: 16bit Interface: parallel Case: DIP28 warm-up time: 1 min Mechanical Description: The digital...

Stereo slide potentiometer with 30mm travel and 10mm Lever. Suitable Slider for Volume Control for Roland D10 Roland D20 Roland D50 This Lever is a little bit thinner than the original one. Electrical properties: The stereo nominal...

Phone Jack 1/4 inch- 6.3 mm, stereo, for printed circuit used in Korg, Roland or Yamaha Instruments this phone jack corresponds to these parts: YKB21-5010 HLJ0520-01-010 HLJ1520-01-3010 HTJ-064-10D same PCB layout, different housing...

Phone Jack 1/4 inch- 6.3 mm, Mono for printed circuit used in Korg, Roland or Yamaha Instruments this Phone Jack corresponds to these parts: YKB21-5012 HLJ 4306 HLJ 4306-01-3000 Mono with switch it is used by the following manufatures...

Single pole rocker switch with solder lugs suitable for models Korg MonoPoly Korg PolySix Korg Part Number: 37501600 6A / 250VAC Termination Solder Lug 1 pole Mounting hole: 19,8 x 12,8 mm Dimensions outside: 20,8 x 14,8 mm VDE-tested...

Power cabel 2m with 2P plug for Roland Instruments VDE tested Cable: H05VV-F2G0,75mm² Length: 2 m Also for Korg Akai

tactile switch suitable for models Roland D-50, D-70 Juno 1, Juno 2, Juno 106, Juno 106S G-800 S50 W30 Roland Part Number: 13169633 and 13129753 The buttons are firmly soldered to a circuit board. For replacing the button craftsmanship...

1 pcs. Single Button for 17 x 5 mm with Window Roland D-70 Roland FP-8 Do you know this: the button you activate don't react. This processs starts slowly and in the beginning do don't recognice it. Later you start to activate...