Spare parts and replacement keys for Korg electribe series GrooveBox

Encoder 16 mm widht suitable for Korg Electribe EMX1 only EC1 Korg i2, i3, i4 Korg Trinity, Trinity Plus, Trinity Pro Practical advice: The thread of this encoder is 2 mm longer than the thread of the Original encoders. Depending on the...

1 pcs. Cap rectangular for power switch Please note the dimensions. The original caps used to be larger on many instruments. Dimensions: 12 x 7 mm Hight: 10 mm

1 pcs. Rotary Potentiometer vertikal 11x11 mm. 10kOhm Substitute rotary potentiometer for Korg Kronos - MIX Section Roland MC-909 Yamaha RS-7000 - without Center Click The here shown substitute fits also in Korg M3 Korg electribe EMX1...

Rotary Potentiometer vertikal 11x11 mm with center click, 10kOhm Substitute rotary potentiometer for Roland MC-909 The rotary pot fits also in Korg electribe EMX1 Korg electribe ESX1 here the axis sticks out 2,5 mm. Electrical...

1 pcs. Replacement stereo rotary potentiometer 12mm widht suitable for Korg EMX1 Korg ESX1 Not a 1:1 spare part. The original potentiometer is threaded. Electrical properties: The stereo nominal resistance has 10 Kilo-Ohm, the electric...

Phone Jack 1/4 inch- 6.3 mm, stereo with switch, for printed circuit used in Korg, Roland or Yamaha Instruments this phone jack corresponds to these parts: YKB21-5074 SCJ630P5 PJ603 Technical description : The offered phone jack for PCB...

1 pcs. Single-pole push switch in the switch design - OFF with solder Pins for PCB mounting suitable for models Korg EA-1 Korg EMX-1 Korg ER-1 Korg Part Number: 375014800 technical Dates: Voltage: 250VAC Current: 5A Termination Solder...

1 pcs. DC Power Jack with solder Pins for PCB mounting suitable for models Korg ESX-1 SD Korg SP-170 technical Dates: Termination Solder Pin Outer Diameter: 5,9 mm Inner diameter: 3 mm Inner contact: 1.05 mm Mechanical Description: outer...

1 pcs. DC Power Plug suitable for models Korg electribe These Power Jack comes from a different Manufacturer but is very well suitable for Roland Instruments. Only Solder pins are little bit smaler. technical Dates: Termination Soldering...

1 piece LED 2 mm Green The LED are firmly soldered to a circuit board. For replacing craftsmanship and experience in soldering is required.

1 piece LED 2 mm Red The LED are firmly soldered to a circuit board. For replacing craftsmanship and experience in soldering is required.

1 pcs. slide potentiometer with 45mm travel without center click Korg EMX-1 Arpeggiator Attention: Without Center click Electrical properties: The stereo nominal resistance has 10 kOhm (Kilo-Ohm), the electric resistance gradient is...