Yamaha CLP-950

Panasonic

tactile switch 7 mm Yamaha

1 pcs. tactile switch suitable for Yamaha MotifOn Yamaha Motif modells these switch is for lightning buttons.These switch is also suitable forYamaha PSR9000Yamaha Tyros serie - without LCD BoardYamaha Part Number: VV439800,WG31840R, VQ371700The buttons are firmly soldered to a circuit board. For replacing the button craftsmanship and experience in soldering is required.why should I solder new pushbutton

€ 0 .71*

Yamaha

Yamaha GH3 NL2 Stopper Upper 88, felt

1 pcs. Yamaha GH3/NL2 Stopper U88 V8468201This GH3 keyboard is used in these modells and others:Yamaha CLP-270This felt is also used in older Yamaha GHD keyboards. Old spare part no is: VU34210R

€ 34 .89*

Yamaha

Yamaha GH3 Stopper Lower88

1 pcs. Yamaha GH3/NL2 Stopper L88 - lower Felt V7640101This GH3 keyboard is used in these modells and others:Yamaha CLP-270This felt is also used in older Yamaha GHD keyboards.

€ 27 .49*

Yamaha

Replacement Keys Yamaha GHD Keyboard

Taste: Key A

Replacement Keys for Yamaha GHD KeyboardThese Keys fits for all Yamaha GHD keyboards.Note on the keys supplied - black rubber:The keys are normally supplied without the black rubber buffer that is attached to the lower end of the key. The black rubber must be taken from the old key.Yamaha GHD keyboard is used in:Yamaha Clavinova CLP-120Yamaha Clavinova CLP-150Yamaha Clavinova CLP-220Yamaha Clavinova CLP-320Yamaha Clavinova CLP-880Yamaha Clavinova CLP-910Yamaha Clavinova CLP-930Yamaha Clavinova CLP-950Yamaha CVP-107Yamaha CVP-109Yamaha Motif 8 und Yamaha Motif ES8Yamaha P-80Yamaha P-120Yamaha P-200This list of Yamaha Clavinova models is only a small selection. These keys were used in many models.Hanging Keys:In a series of these keyboards there was a problem with so-called hanging keys caused by the use of an unsuitable plastic grease.The key is clicked into the keyboard frame at the rear end. Yamaha originally used white grease here. This plastic grease has attacked the plastic of the key's. In the long run, this led to a material break at the back side of the key's (see photo 2).By this material break, the key is a bit wrong and thereby strikes the key next to it, dragging and is thus difficult (hangs). Instruments affected between May 2000 and January 2003 are affected.Today Yamaha uses a blue keyboard grease which is suitable for the plastic keys. If you still find this white grease in your keyboard, it is recommended to remove this grease and replace it with the blue one. For a keyboard should be 10 to 20 grams of grease.The Yamaha GHD keyboard is a velocity-sensitive keyboard, which comes in 2 versions.With a 4-zone hammer mechanism and a simple hammer mechanism in which all hammers are equally weighted.Mechanical construction:The base frame of the keyboard is made of plastic and is therefore very light. All other components are attached to this frame by screws or clamps.The white Keys have a size in cm of 2,2x21x4,2, the black Keys 2,2x19,2x5,9 cm.

Variants from €6.89*

€ 8 .89*

Yamaha

Yamaha GH3 Actuate Rubber

1 pcs. Yamaha GH3 Actuate RubberThis rubber fits in these keyboardsYamaha GHDYamaha GH3Yamaha NL2This rubber is used on every single key as stopperColor: black

€ 2 .08*

E-Switch

Single pole push switch, 250V/5A with solder lugs SDDLD10900

Single-pole push switch in the switch design - OFF with solder terminals for cable assembly suitable for modelsKorg M1, M1RKorg T1, T2, T3Korg Part Number: 375006100The power switch corresponds to the ALPS switches SDDLD10900 TV5. This is no longer manufactured by ALPS.Termination Solder LugMounting holes with threadVDE-tested Supplied without capMechanical Description:The housing of the switch is made of nylon 66. The switch is provided for a screw in a housing and has two threaded holes for M3 x 0.5 screws. The spacing of the mounting holes is 20 mm. The housing cut job of performing the switching element should be 4x4 mm. The switch itself has a width of 10 mm, a length of 27 mm and a height of 17.90 mm. The protruding switching element has a length of 18 mm. Electrical properties:The electrical components are made of copper with a silver or tin plating. The electrical connection is made with solder connections for cable assembly. The length of the terminals is 4.2 mm and a width of 3 mm.The electrical load is 5 A at 250 VAC.Knowledge in soldering is required for switch replacement.

€ 6 .95*

Yamaha

Yamaha Keyboard grease, blue 50g

Yamaha Spezial Keyboard grease, Blue 50gOriginal Yamaha plastic grease for Keyboards. Color is blue and will be delivered in a 50 gramm portion.Molycote G-1066YThis grease is used on YamahaOn GHD and GH3 keyboards on the fulcrum - Where the key engages the frame.For pedals at the mechanical moving parts.

€ 35 .50*

Yamaha

Yamaha pedal felt black for E-Piano

1 pcs. Yamaha pedal felt black for E-PianoThe felt is coated with adhesive film on one side.

€ 2 .94*

Jalco

Phone Jack 1/4 - 6.3 mm PCB Stereo with switch

Phone Jack 1/4- 6.3 mm, Stereo with switch, for printed circuit used in Korg, Roland or Yamaha InstrumentsThis part is used inKorg OasysRoland Juno GYamaha Tyros 2 Technical descriptionThe offered phone jack for PCB mounting is a stereo jack with switching contact for 1/4 inch. The housing is made of black synthetic material and the electrical parts are made of a copper alloy with a tin coating. Praktikal tip:These phone jack is firmly soldered to a circuit board. For replacing craftsmanship and experience in soldering is required.

€ 5 .81*

Yamaha

Yamaha Contactrubber 88P new

1 pcs Yamaha Contactrubber 88P newThis contact rubber was installed in different Yamaha keyboards and there are different spare part numbers for this spare part.A note about the contact rubbers: The contact rubber for the 88's keyboard was available in the colors pink and green. The pink contact rubber is missing 2 holes in the rubber which serve as a guide.The green version is no longer available.Note for the installation of the Yamaha contact rubber:Please pay attention to the installation position! The interruptions in the Konaktstreifen are not symmetrical.

€ 36 .89*

Synth-Parts

Power cable 2 pol for EU, 1.8m

1 pcs. Power cabel 1,8 m with 2P plug for Europe

€ 6 .89*

Yamaha

Yamaha GHD one octae white keys

One Octave white Replacement Keys for Yamaha GHD KeyboardThis set contains:1 x A1 x B1 x C1 x D1 x E1 x F1 x GNote on the keys supplied - black rubber:The keys are normally supplied without the black rubber buffer that is attached to the lower end of the key. The black rubber must be taken from the old key.

€ 58 .49*

Yamaha

Yamaha GHD A88 Keyboard complete

1 pcs. Yamaha GHD A88 Keyboard complete--- shipping only in germany, sorry -----Please ask if this keyboard is the right one for your e-piano model.This keyboard was used for many years in the vast majority of Yamaha electric piano models.The replacement of the entire keyboard is from a certain age of the electric piano well worth considering.For example, if your original keyboard is affected by the grease problem, you have here an alternative after desen exchange you no longer have to worry about the keyboard.If the keyboard is not in stock, we can order the keyboard from Yamaha. There may be a delivery time.

€ 399 .00*

ALPS

Yamaha Stereo Potentiometer CLP-120

1 pcs. Slidepotentiometer. Suitable for Volume Slider inYamaha CLP-120Yamaha CLP-430Yamaha CLP-920Yamaha CLP-990Yamaha P-105Yamaha P-120 The slider is firmly soldered to a circuit board. For replacing the button craftsmanship and experience in soldering is required.

€ 9 .45*

Yamaha CLP-950 feature

The pedal support screw is missing. Yes, this is quite unusual because all electric pianos actually use a pedal support screw. The Clavinova CLP-950 electric piano model does not have a support screw.

Yamaha Clavinova CLP-950 spare parts easy to buy online

The Yamaha Clavinova CLP-950 digitalpiano is a digital piano designed for professional use by professional and amateur musicians. If an electric piano from Yamaha is used a lot then the individual components of the Yamaha CLP-950 electric piano are subject to wear. Anyone who likes to play a lot on his Yamaha Clavinova CLP-950 e-piano will need a key from the keyboard as a spare part at some point. But also the contact rubber or the sensorboard in the keyboard of the Yamaha CLP-950 e-piano may need to be replaced by a new component. During frequent use of headphone of the Clavinova e-piano the phone jack are stressed hard. Also power supply or the power cord are parts that can be damaged over time. If after many years of trouble-free music making you can hear crackling and popping in the speaker, then most likely the volume control is defective. With us you can easily buy a new potentiometer for your Yamaha CLP-950 Digital Piano.

We supply spare parts for Yamaha Clavinoava CLP-950 electric piano worldwide.

We are your reliable supplier for spare parts of your Yamaha Clavinova CLP-950 electric piano. We offer our spare parts like phone jack socket, tact switch or volume potetniometer in our online store. We also have the matching potentiometer usually permanently in stock. Original Yamaha spare parts like contact rubber, key and sensorboard we also have in our assortment. Spare parts we have partly also in OEM quality for the Yamaha Clavinova CLP-950 electric piano in stock. For us OEM quality means that we get spare parts such as tact switch, potentiometer or phone jack directly from the same supplier from which Yamaha buys the components. Our original Yamaha spare parts like sliptape, contact rubber or sensorboard are usually shipped with Deutsche Post or DHL. If the delivery of your needed spare part for the Yamaha Clavinova CLP-950 E-Piano is especially urgent, please contact us. We can also organize an express delivery with UPS.

Filter products

Yamaha CLP-950

Yamaha CLP-950 feature

Yamaha Clavinova CLP-950 spare parts easy to buy online

We supply spare parts for Yamaha Clavinoava CLP-950 electric piano worldwide.