Friedrich-Engels-Allee 161A, 42285 Wuppertal, Germany
We 10 am - 5 pm
Fr 10 am - 2 pm
Or via our contact form.
Go to homepage
€0.00

Filter products

E-Mu Proteus 2

Tactile switch 15,4 mm
Synth-Parts
Tactile switch 15,4 mm
Tactile switch suitable for  The buttons are firmly soldered to a circuit board. For replacing the button craftsmanship and experience in soldering is required.Why should I solder new pushbutton

€ 3 .36*
E-Mu Proteus OLED Display NEW
Synth-Parts
E-Mu Proteus OLED Display NEW
Color: Blue
1 pcs. OLED Display New forE-Mu Proteus 1E-Mu Proteus 2E-Mu Proteus 3To replace this display you need very good knowledge in soldering. The original display is soldered firmly to the board via a pin header. To disassemble the old display, this pin header must be cleaned very cleanly from the solder.An installation manual is enclosed with the display.These different Display versions are available:BlueRed/OrangeYellowWhiteLifetime:The lifetime is specified by the manufacturer with 50,000 operating hours. After this specified drive time, the display still has 50% of its original luminosity. 

€ 48 .99*
1 pcs. Cap round for power switch
Synth-Parts
1 pcs. Cap round for power switch
 1 pcs. Cap round for power switch

€ 2 .44*
E-Mu triple female MIDI Socket for PCB, Jalco, YKF51-5046
Jalco
E-Mu triple female MIDI Socket for PCB, Jalco, YKF51-5046
1 pcs. triple MIDI DIN socket female 5 pin for printed circuit for E-MuJalco YKF51-5046 Please look carefully. This MIDI socket is also available in a version in which the DIN sockets are rotated by 180 degrees. This is a 1:1 replacement for the MIDI jack in most e-mu sampler.These part is firmly soldered to a circuit board. For replacing craftsmanship and experience in soldering is required.

€ 10 .89*
Cap round 12 mm for tact switch
Synth-Parts
Cap round 12 mm for tact switch
 1 pcs. Cap round 12 mm for tact switchThis cap for stylus has a diameter of 12 mm and a receptacle of 3 x 3 mm.Suitable as a spare part for E-Mu sampler

€ 3 .39*
E-Mu Phone Jack 1/4 - 6.3 mm for printed circuits Stereo with one Switch
Nord
E-Mu Phone Jack 1/4 - 6.3 mm for printed circuits Stereo with one Switch
1 pcs. Phone Jack 1/4- 6.3 mm, stereo witch one Switch, for printed circuit used by E-mu E4KE-mu E-SynthE-Mu E4 XTE-Mu e6400Technical description:The offered phone jack for PCB mounting is a stereo jack with switching contact for 1/4 inch. The housing is made of black synthetic material and the electrical parts are made of a copper alloy with a tin coating. Praktikal tip:These phone jack is firmly soldered to a circuit board. For replacing craftsmanship and experience in soldering is required.

€ 7 .84*