Yamaha CLP-170

Panasonic

tactile switch 7 mm Yamaha

1 pcs. tactile switch suitable for Yamaha MotifOn Yamaha Motif modells these switch is for lightning buttons.These switch is also suitable forYamaha PSR9000Yamaha Tyros serie - without LCD BoardYamaha Part Number: VV439800,WG31840R, VQ371700The buttons are firmly soldered to a circuit board. For replacing the button craftsmanship and experience in soldering is required.why should I solder new pushbutton

€ 0 .71*

Yamaha

Yamaha GH3 NL2 Stopper Upper 88, felt

1 pcs. Yamaha GH3/NL2 Stopper U88 V8468201This GH3 keyboard is used in these modells and others:Yamaha CLP-270This felt is also used in older Yamaha GHD keyboards. Old spare part no is: VU34210R

€ 34 .89*

Yamaha

Yamaha GH3 Stopper Lower88

1 pcs. Yamaha GH3/NL2 Stopper L88 - lower Felt V7640101This GH3 keyboard is used in these modells and others:Yamaha CLP-270This felt is also used in older Yamaha GHD keyboards.

€ 27 .49*

Yamaha

Replacement Keys Yamaha GHD Keyboard

Taste: Key A

Replacement Keys for Yamaha GHD KeyboardThese Keys fits for all Yamaha GHD keyboards.Note on the keys supplied - black rubber:The keys are normally supplied without the black rubber buffer that is attached to the lower end of the key. The black rubber must be taken from the old key.Yamaha GHD keyboard is used in:Yamaha Clavinova CLP-120Yamaha Clavinova CLP-150Yamaha Clavinova CLP-220Yamaha Clavinova CLP-320Yamaha Clavinova CLP-880Yamaha Clavinova CLP-910Yamaha Clavinova CLP-930Yamaha Clavinova CLP-950Yamaha CVP-107Yamaha CVP-109Yamaha Motif 8 und Yamaha Motif ES8Yamaha P-80Yamaha P-120Yamaha P-200This list of Yamaha Clavinova models is only a small selection. These keys were used in many models.Hanging Keys:In a series of these keyboards there was a problem with so-called hanging keys caused by the use of an unsuitable plastic grease.The key is clicked into the keyboard frame at the rear end. Yamaha originally used white grease here. This plastic grease has attacked the plastic of the key's. In the long run, this led to a material break at the back side of the key's (see photo 2).By this material break, the key is a bit wrong and thereby strikes the key next to it, dragging and is thus difficult (hangs). Instruments affected between May 2000 and January 2003 are affected.Today Yamaha uses a blue keyboard grease which is suitable for the plastic keys. If you still find this white grease in your keyboard, it is recommended to remove this grease and replace it with the blue one. For a keyboard should be 10 to 20 grams of grease.The Yamaha GHD keyboard is a velocity-sensitive keyboard, which comes in 2 versions.With a 4-zone hammer mechanism and a simple hammer mechanism in which all hammers are equally weighted.Mechanical construction:The base frame of the keyboard is made of plastic and is therefore very light. All other components are attached to this frame by screws or clamps.The white Keys have a size in cm of 2,2x21x4,2, the black Keys 2,2x19,2x5,9 cm.

Variants from €6.89*

€ 8 .89*

Yamaha

Contactrubber GH3 for Yamaha

Contactrubber GH3 suitable for Yamaha This keyboard is used in these modells:Yamaha CVP-305Yamaha CVP-307For a complete Keybord with 88 keys you will need this quantity on contactrubber:1 x 5P6 x 12P1 x 11P

€ 13 .19*

Jalco

YKB21-5006 - Phone Jack 1/4- 6.3 mm for printed circuits Stereo

1 pcs. Phone Jack 1/4 inch - 6.3 mm, stereo with 2 switch, printed circuit for Korg, Roland or Yamaha Instrumentsthis Phone Jack corresponds to these parts:YKB21-5006HLJ-4306-01-3040HTJ-064-04These phone jack is firmly soldered to a circuit board. For replacing craftsmanship and experience in soldering is required.

€ 6 .88*

Yamaha

Yamaha GH3 Actuate Rubber

1 pcs. Yamaha GH3 Actuate RubberThis rubber fits in these keyboardsYamaha GHDYamaha GH3Yamaha NL2This rubber is used on every single key as stopperColor: black

€ 2 .08*

E-Switch

Single pole push switch, 250V/5A with solder lugs SDDLD10900

Single-pole push switch in the switch design - OFF with solder terminals for cable assembly suitable for modelsKorg M1, M1RKorg T1, T2, T3Korg Part Number: 375006100The power switch corresponds to the ALPS switches SDDLD10900 TV5. This is no longer manufactured by ALPS.Termination Solder LugMounting holes with threadVDE-tested Supplied without capMechanical Description:The housing of the switch is made of nylon 66. The switch is provided for a screw in a housing and has two threaded holes for M3 x 0.5 screws. The spacing of the mounting holes is 20 mm. The housing cut job of performing the switching element should be 4x4 mm. The switch itself has a width of 10 mm, a length of 27 mm and a height of 17.90 mm. The protruding switching element has a length of 18 mm. Electrical properties:The electrical components are made of copper with a silver or tin plating. The electrical connection is made with solder connections for cable assembly. The length of the terminals is 4.2 mm and a width of 3 mm.The electrical load is 5 A at 250 VAC.Knowledge in soldering is required for switch replacement.

€ 6 .95*

Yamaha

Yamaha Keyboard grease, blue 50g

Yamaha Spezial Keyboard grease, Blue 50gOriginal Yamaha plastic grease for Keyboards. Color is blue and will be delivered in a 50 gramm portion.Molycote G-1066YThis grease is used on YamahaOn GHD and GH3 keyboards on the fulcrum - Where the key engages the frame.For pedals at the mechanical moving parts.

€ 35 .50*

Jalco

YKB21-5076 - Phone Jack 1/4- 6.3 mm PCB Mono

1 pcs. Phone Jack 1/4 inch - 6.3 mm, Mono witch switch, printed circuit for Korg, Roland or Yamaha Instrumentsthis Phone Jack corresponds to these parts:YKB21-5076HLJ-2305-01-3030These phone jack is firmly soldered to a circuit board. For replacing craftsmanship and experience in soldering is required.

€ 4 .25*

Yamaha

Yamaha pedal felt black for E-Piano

1 pcs. Yamaha pedal felt black for E-PianoThe felt is coated with adhesive film on one side.

€ 2 .94*

Jalco

Phone Jack 1/4 - 6.3 mm PCB Stereo with switch

Phone Jack 1/4- 6.3 mm, Stereo with switch, for printed circuit used in Korg, Roland or Yamaha InstrumentsThis part is used inKorg OasysRoland Juno GYamaha Tyros 2 Technical descriptionThe offered phone jack for PCB mounting is a stereo jack with switching contact for 1/4 inch. The housing is made of black synthetic material and the electrical parts are made of a copper alloy with a tin coating. Praktikal tip:These phone jack is firmly soldered to a circuit board. For replacing craftsmanship and experience in soldering is required.

€ 5 .81*

Synth-Parts

Power cable 2 pol for EU, 1.8m

1 pcs. Power cabel 1,8 m with 2P plug for Europe

€ 6 .89*

Yamaha

Yamaha Pedal screw long

1 pcs. Yamaha Pedal screwDimensions: M6 x 57 mmNote:At 38 mm, this pedal support bolt has a longer thread than the one under item numberSCYA-WF054500

€ 9 .45*

Yamaha

Yamaha GHD one octae white keys

One Octave white Replacement Keys for Yamaha GHD KeyboardThis set contains:1 x A1 x B1 x C1 x D1 x E1 x F1 x GNote on the keys supplied - black rubber:The keys are normally supplied without the black rubber buffer that is attached to the lower end of the key. The black rubber must be taken from the old key.

€ 58 .49*

Yamaha

Hammer Yamaha GHD Keyboard

Hammer: Hammer Zone 1 black key

Replacement Hammer for Yamaha GHD Keyboard The Yamaha GHD Keyboard is used in two different configurations.The Keyboard is availabel with a 1 zone Hammeraction and with a 4 Zone Hammeraction.Here you will find the different Hammer for the GHD Keyboard

€ 9 .48*

ALPS

Yamaha Potentiometer CLP-150 centerclick

1 pcs. Slidepotentiometer with center click suitable for Yamaha CLP-150Yamaha CLP-170The slider is firmly soldered to a circuit board. For replacing the button craftsmanship and experience in soldering is required.

€ 9 .45*

ALPS

1,44 MB Disc ALPS DF354H

1 pcs. 1,44 MB Disc ALPS DF354H

€ 58 .99*

Yamaha

Yamaha CLP-170 Mainboard DM tested with 1 year warranty

1 pcs. Mainboard for Yamaha CLP-170 E-PianosThese Mainboard is tested by us and fully working. We sell it with one year warranty.Is your e-piano faulty or no sound?Even if we do not have the appropriate board in stock, we can repair your board - with warranty. Usually it is enough if you send us the mainboard and the AmpBoard.

€ 264 .97*

Yamaha

Yamaha Pedal PCB X0193 for E-Pianos V7675600

1 piece Yamaha Pedal PCB X0193 for E-Pianos V7675600This PCB for Yamaha pedal unit is used in pedals in which three potentiometers are installed.For final use, parts on the board still have to be broken off. The break edges are marked and perforated accordingly. This can be done easily and without tools.

€ 27 .89*

Yamaha

1 pcs. Yamaha GH3 GKS A88 Keyboard complete

1 pcs. Yamaha GH3 GKS A88 Keyboard completeThis keyboard is used in these modells:Yamaha CLP-170Yamaha CLP-230Yamaha CLP-265GPYamaha CLP-270Yamaha CLP-430Yamaha CLP-465GPColor: cremewhiteShipping only with UPS and within Germany. Sorry.

€ 575 .00*

Yamaha

POWER SWITCH ASSY CLP-170

1 pcs. POWER SWITCH ASSY CLP-170Semiconductors and electronic assemblies are sensitive to electrostatic charge. Please observe the regulations on ESD handling.The exchange and return of semiconductors and electronic assemblies is excluded after opening the packaging.

€ 22 .57*

Yamaha Clavinova CLP-170 spare parts easy to buy online

The Yamaha Clavinova CLP-170 digitalpiano is a digital piano designed for professional use by professional and amateur musicians. If an electric piano from Yamaha is used a lot then the individual components of the Yamaha CLP-170 electric piano are subject to wear. Anyone who likes to play a lot on his Yamaha Clavinova CLP-170 e-piano will need a key from the keyboard as a spare part at some point. But also the contact rubber or the sensorboard in the keyboard of the Yamaha CLP-170 e-piano may need to be replaced by a new component. During frequent use of headphone of the Clavinova e-piano the phone jack are stressed hard. Also power supply or the power cord are parts that can be damaged over time. If after many years of trouble-free music making you can hear crackling and popping in the speaker, then most likely the volume control is defective. With us you can easily buy a new potentiometer for your Yamaha CLP-170 Digital Piano.

We supply spare parts for Yamaha Clavinoava CLP-170 electric piano worldwide.

We are your reliable supplier for spare parts of your Yamaha Clavinova CLP-170 electric piano. We offer our spare parts like phone jack socket, tact switch or volume potetniometer in our online store. We also have the matching potentiometer usually permanently in stock. Original Yamaha spare parts like contact rubber, key and sensorboard we also have in our assortment. Spare parts we have partly also in OEM quality for the Yamaha Clavinova CLP-170 electric piano in stock. For us OEM quality means that we get spare parts such as tact switch, potentiometer or phone jack directly from the same supplier from which Yamaha buys the components. Our original Yamaha spare parts like sliptape, contact rubber or sensorboard are usually shipped with Deutsche Post or DHL. If the delivery of your needed spare part for the Yamaha Clavinova CLP-170 E-Piano is especially urgent, please contact us. We can also organize an express delivery with UPS.

Filter products

Yamaha CLP-170

Yamaha Clavinova CLP-170 spare parts easy to buy online

We supply spare parts for Yamaha Clavinoava CLP-170 electric piano worldwide.