No results were found for the filter!
1 pcs. Sanjo Battery with solder tail suitable for Roland Juno 60 Please check right polarity! Attention: Shipping for Europe only The batterie is firmly soldered to a circuit board. For replacing craftsmanship and experience in...
6.99€ *
1 pcs. Varta Battery with solder tail suitable for Roland Juno 60 Please check right polarity! Attention: Shipping for Europe only The solder tail is about 0.5mm too wide to fit through the slot in the circuit board. The batterie is...
6.99€ *
1 pcs. Replacement stereo rotary potentiometer suitable for volume control in Roland Juno 6 Roland Juno 60 Roland JX3P Electrical properties: The stereo nominal resistance has 10 Kilo-Ohm, the electric resistance gradient is linear. The...
From 9.90€ *
1 pcs. Push Switch with solder Pins for PCB mounting suitable for Roland Juno 60 - Hold, Arpeggio technical Dates: Termination Solder Pin Supplied without cap Practical advice: Knowledge in soldering is required for switch replace ment .
14.98€ *
Phone Jack 1/4 inch- 6.3 mm, Stereo with two switch, for printed circuit used in These Phone Jack is in a simple version used in Roland Juno 6 Roland Juno 60 Technical description : The offered phone jack for PCB mounting is a stereo...
3.65€ *
Single pole rocker switch with solder lugs suitable for models Korg MonoPoly Korg PolySix Korg Part Number: 37501600 6A / 250VAC Termination Solder Lug 1 pole Mounting hole: 19,8 x 12,8 mm Dimensions outside: 20,8 x 14,8 mm VDE-tested...
4.76€ *
1 pcs. new Slide potentiometer with 30mm travel. Suitable Slider for Slider for Roland Juno 6 HPF,VCF FRQ,VFC RES, Bender VCF Roland Juno 60 all, without Arp-Rate, LFO-Rate, Bender DCO Electrical properties: The nominal resistance has 50...
From 10.34€ *
1 pcs. new Slide potentiometer with 30mm travel. Suitable Slider for Slider for Roland Juno 6 LFO Rate, DCO LFO,SUB OSC, NOISE Roland Juno 60 LFO-Rate Electrical properties: The nominal resistance has 50 KOhm, the electric resistance...
From 10.34€ *
1 pcs. new Slide potentiometer with 30mm travel. Suitable Slider for Slider for Roland Juno 6 Bender-DCO Roland Juno 60 Bender-DCO Electrical properties: The nominal resistance has 1 MOhm, the electric resistance gradient is logarithmic....
From 10.34€ *
1 pcs. new Slide potentiometer with 30mm travel. Suitable Slider for Slider for Roland Juno 6 ARP RATE,DELAY TIME Roland Juno 60 Arpeggio Rate Electrical properties: The nominal resistance has 1 MOhm, the electric resistance gradient is...
From 10.34€ *
Roland Roland Juno 60 Fader Set complete This Set contains: 1 pcs. Fader 30mm 10KB 1 pcs. Fader 30mm 50KA 1 pcs. Fader 30mm 1MA 16 pcs. Fader 30mm 50KB Useful hint: Potentiometer are soldered on the circuit board. You should have...
173.99€ *
1 pcs. Battery holder for CR2032 for PCB mounting Attention: Shipping for Europe only Technical Description: Information for handling old Battery's
16.59€ *
Viewed