Technics
1 pcs. Technics Tapping Screw XTW3+10T Keyboardscrew These screws were removed and tested from a Technicsdevice.The N-Numbers from the service manual are assigned differently depending on the device. To avoid misunderstandings, we use the screw designations from the manual. Dimensions: 3 x 12,5mm ScreLocation: PCB in KeyboardXTW3+10T in Service Manual.
1 pcs. Technics Tapping Screw XTN4+50AFZ Keyboardscrew These screws were removed and tested from a Technicsdevice.The N-Numbers from the service manual are assigned differently depending on the device.To avoid misunderstandings, we use the screw designations from the manual.Dimensions: 4 x 50 mmScrew XTN4+50AFZ in Service Manual.
Speaker plug 6 pin for Technics E-PianosThis plug is used in Technics E-Pianos for connecting the speaker sitting in the Stand fomr the Piano.
1 pcs. Transformer Technics QTPG1M029AThis Transformer is usedd and in a good condition.The primary cause of a defective, e.g. To make matters worse, most devices are only protected on the primary side of the transformer with a microfuse. In this situation, the transformer operates in overload, which in turn leads to overheating of the transformer.
1 pcs. Transformer Technics PR603This Transformer is usedd and in a good condition.suitable forTechnics PR603technical Hint:The primary cause of a defective, e.g. To make matters worse, most devices are only protected on the primary side of the transformer with a microfuse. In this situation, the transformer operates in overload, which in turn leads to overheating of the transformer.
AC-IN Circuit QJBG2164 for Technics, usedThese board is tested by us and fully working. We sell it with one year warranty.
Pitch bend Assembly suitable forTechnics KeyboardsWe offer here all replacement parts you will need to repair your Technics Pitch Bend Assembly. Our parts are used and in a good condition.
1 pcs. brand new LCD Display with blue LED backlight suitable forTechnics PR-602Technics PR-702Technics PR-902Technics PR-603Technics PR-703Technics PR-903Technics PR-1000The LCD displays built into the PR-603, PR-703 or PR-903 e-piano series by Technics are now aging. The original displays have a small fluorescent tube, a so-called CCFL backlight, as backlight. It is possible that only the backlight is defective or the whole display is defective. This can be that only single pixels in the display are missing or whole lines in the LCD no longer work. In extreme cases, entire areas of the screen can also fail. If only the CCFL backlight is defective you can use a new fluorescent tube. The whole thing requires very calm hands and patience because these backlight tubes have a diameter of only 2 mm. Therefore they are very sensitive and delicate. Here it is also necessary to solder. As an alternative we offer a replacement LCD equipped with modern LED backlight. If the display already has major defects or if you want to save yourself the soldering effort, this replacement display is a good choice. Scope of delivery:1 pc. new LCD display, ready wiredAssembly materialshort installation instructions Notes on installation:Please be aware that you are opening an electrical device that is supplied with 230 volts. This work should only be carried out by people who have the appropriate expertise.We have prepared everything so that the installation on your electric piano is as easy as possible. With the replacement display you will receive all the necessary parts for the installation. No soldering work is required. All cables are plugged in. Notes on disposal:Each electronic component contains important raw materials that should be recycled. Please find out where in your area there is a corresponding collection point for these components.
Key's for a Technics E-Piano, 88 Key HammeractionThe keys are used and in good condition. All keys supplied by us have been cleaned and checked.Since these are used keys, color deviations may occur. Technics has always used the same keyboard for many years. We think Technics has used a very good and above all durable keyboard.
versenkbare Tastaturabdeckung für Technics E-PianosTastaturabdeckungMontageschiene AluminiumStange, AluminiumHalter für StangeZahnradBei E-Pianos oder Digitalpianos von Technics ist es Standard das es eine versenkbare Tastaturabdeckung gibt. Die Tastaturabdeckung wird leicht angehoben und rollt dann sehr leicht in das innere des Pianos und gibt die Tastatur frei.Die Tastaturabdeckung ist ein Deckel der aus dem gleichen Material gefertigt ist wie der Korpus des Pianos. In der Regel ist das Spanplatte oder MDF-Platte. An der Vorderseite ist wahlweise eine Aluminiumschiene oder ein Holzsteg befestigt durch den der Deckel im geschlossenen Zustand auf dem Korpus des Pianos aufliegt. An der Rückseite ist eine durchgehende Aluminiumstange montiert. An jedem Ende dieser Stange ist ein Zahnrad aus Kunststoff befestigt. Diese Zahnräder bewegen sich auf Zahnstangen die im innern des Pianos am Korpus befestigt sind.
Contact rubber Version 1 for Technics KeyboardThis contact rubber version is run without any maintenance bumps. The contact rubber is held in a special frame.For the complete exchange of the contact strips in a keyboard with 61 keys 4 contact rubbers with 12 contacts and 1 contact rubber with 13 contacts are required.Contact high: 9.5 mmStrip bright: 26 mmStrip length: 164 / 179 mmNumber of contacts: 12 or 13A rubber contact strip consists of 12 or 13 contacts and covers an octave. For complete replacement of the rubber contact strips in a keyboard with 61 keys you will need 4 contact rubber with 12 contacts and 1 contact rubber with 13 contacts.
Spare Parts for SK25 Keyboard Here you will find parts for SK25 Keyboard, like Felts, Springs and Contact Rubber
Recapping set for Technics SX-PX1 E-PianoThe wear parts of the electronics are electrolytic capacitors. Capacitors are aging, and you will see the effect at first when it comes to greater damage because of overvoltage.With an age of more than 30 years, the Technics PX-1 is in any case one of the instruments in which an replacement of all electrolytic capacitors is strongly advised.Our recapping set is made up of Capacitors, which have been specially developed for use in audio applications. The manufacturer Nichicon is for us the manufacturer with a good quality at reasonable prices offers.This Recapping Set contains all necessary Capacitors for complete Technics SX-PX1 E-Piano. The Capacitors are firmly soldered to a circuit board. For replacing the button craftsmanship and experience in soldering is required.
1 pcs. Technics ASUB Circuit Board QJBG2298 repairedTechnics SXPR-602Technics SXPR-603Technics SXPR-702Technics SXPR-703These circuit board was repaired by us and is tested and fully working.important note - complex electronic errorFaults in the amplifier circuitry of these Technics electric pianos are very complex and require extensive electronics knowledge and professional experience.A new ASUB board is only part of the solution.We do not assume any warranty if a new ASUB board is inserted into a defective amplifier.
Mainboard for Technics E-PianosTechnics SXPX-222Technics SXPX-332These Mainboard is tested by us and fully working. We sell it with one year warranty.Is your e-piano faulty or no sound?Even if we do not have the appropriate board in stock, we can repair your board - with warranty. Usually it is enough if you send us the mainboard and the AmpBoard.
1 pcs. brand new OLED Display forTechnics PR-170Technics PR-270Technics PR-370Especially the electric pianos built under the Technics brand are very important to us. A long time ago the support by the manufacturer was completely stopped so that today no original spare parts are available. Even if Technics has produced in very good quality, some components can break. Partly this is simply due to the aging of the components. We offer here a brand new OLED display as a replacement for the originaly used LCD display. Hints for mounting:To install this new OLED Display, the mechanical installation has to be done a different than the original display. The new OLED display will be delivered by us ready wired. No soldering work is necessary for this installation. Scope of delivery:1 pc. new OLED display, ready wiredMounting materialshort installation instruction Notes on disposal:every electronic component contains important raw materials that should be recycled. Please find out where in your city is a corresponding collection point for these components.
1 pcs. Music stand for Technics KeyboardTechnics KN5000This music stand is placed at the rear sideMounting: reare sideMounting design: plugMaterial: Metal, blackz anodizedwide range Note pad: 48 cmwide range top: 45 cmhigh: 20 cmHole distance: 46,5 cmDiameter hole : 5 mm
1 pcs. Music stand for Technics Keyboard usedTechnics KN1000This music stand is placed at the rear sideMounting: reare sideMounting design: plugMaterial: Metal, blackz anodizedwide range Note pad: 45 cmwide range top: 40 cmhigh: 20 cmDiameter hole : 5 mm
1 pcs. LCD Display forTechnics KN6000Technics KN6000This Display is used.
1 pcs. Fader knob suitable for:Technics KN5000Color: Black
Replacement Hammer for Technics SK25 KeyboardThis Keyboard is used in these ModellTechnics PC-25Technics PR-52Technics PR-53Technics PR-54Technics PR-554Technics PR-603Technics PR-604Technics PR-703Technics PR-804Technics PR-903Technics PX-552Technics PX-663The Technics SK25 keyboard is a 4 zone hammer mechanism.The manufacturer uses a total of 8 different hammers, since in addition to the 4 zones, a different hammer is used for the white and black keys.
Technics as a brand of Panasonic Corporation
In 1918, the Japanese Konosuke Matsushita founded the company Matsushita, based in Osaka, Japan. This is the cornerstone of today's Panasonic Corporation, a major corporation known worldwide. Just like the name Panasonic, the name Technics is just a brand name. The Technics brand was introduced by Matsushita Group in 1965. Technics stands for hi-fi equipment and musical instrument at a very high technical and tonal level. In 2008, the Matsushita Group is renamed to Panasonic Corporation. The brand name Panasonic thus becomes the namesake of the group.
Musical instruments from Technics
When the brand Technics was founded in 1965, two product lines were established. On the one hand, hi-fi devices such as amplifiers and turntables. The second product line produces electronic keyboard instruments. The Technics offered organs and electric pianos are at a high level. The processing of the instruments is very good and the sound quality is convincing. In 2010, Panasonic decided to discontinue the production of hi-fi equipment as well as the production of Technics keyboard instruments.
Technics organs
The development history of electronic keyboard instruments is above all a history of the two-manual electronic organ. In today's music world, organs only play a very minor role. It is likely that a two-manual keyboard instrument in the home is next to the size too dominant.
Technics electric pianos
Technics Keyboards
Spare parts, repairs and service
Today, in 2018, Panasonic's support for the Technics musical instruments is completely set. Also at the company Keilitz in Leipzig it is no longer possible to get spare parts for Technics electric pianos or keyboards. As we are convinced of the quality of the electric pianos and keyboards, we continue to provide service for Technics keyboard instruments. In many cases we are able to repair electronic assemblies. Spare parts such as tactile switch, encoders or potentiometers are offered as new in OEM quality. Due to our very good contacts to different suppliers, we are able to offer replacement keys and contact rubbers partly as new. Everything else we offer as far as we can as used parts in a good quality. Especially for the used spare keys, we ask for your understanding that the color of the keys may differ. Due to aging of the keys, the keys are dimmed in many cases.