No results were found for the filter!
Recapping set for E-Mu Proteus1 The wear parts of the electronics are electrolytic capacitors. Capacitors are aging, and you will see the effect at first when it comes to greater damage because of overvoltage. Our recapping set is made...
22.49€ *

1 pcs. OLED Display New for E-Mu Proteus 1 To replace this display you need very good knowledge in soldering. The original display is soldered firmly to the board via a pin header. To disassemble the old display, this pin header must be...
39.00€ *
1 pcs. Encoder 22 mm suitable for some E-MU Systems instruments Practical advice: this encoder was used in some few E-Mu Instruments. Please have a look in your instrument first if this is the right one for you. These encoder is firmly...
10.71€ *
Tactile switch suitable for The buttons are firmly soldered to a circuit board. For replacing the button craftsmanship and experience in soldering is required. Why should I solder new pushbutton
3.36€ *
Phone Jack 1/4- 6.3 mm, stereo witch one Switch, for printed circuit used by E-mu E4K E-mu E-Synth Technical description : The offered phone jack for PCB mounting is a stereo jack with switching contact for 1/4 inch. The housing is made...
7.49€ *
1 pcs. Battery with solder pin suitable for E-Mu Proteus Please check right polarity! Attention: Shipping for Europe only The batterie is firmly soldered to a circuit board. For replacing craftsmanship and experience in soldering is...
14.28€ *
Viewed